What Type Of Plug On 07 Tundra Pre-wired For A Backup Camera

Camera, 4 Wire Plug Connector, well-nigh Spare Tire and
Monitor, x Wire Plug Connector, Nether Front of Overhead Roof Console near Rear View Mirror.
I want to run the video to an in-dash HU instead of the overhead... do y'all know if I can tap the built-in harness in the dash or footwell areas instead of running wires back downward the pillars from the overhead?
longl019 New Member

Joined:

Aug 18, 2018

Member:

#18285

Letters:

2

Gender:

Male

First Name:

Mike

Vehicle:

2011 Toyota Tundra Double Cab

I want to do the same affair as dragon_coma, anyone out in that location know of a adept manner to do this? I have considered just running all new wires from the rear, simply it would make the most sense to use what is already there, just don't want it to be in the over head area. Looking to get an aftermarket unit from crutchfield (head unit of measurement) and wire in the support camera there.
Here's what I did. Bought a camera for 2012-xiii Tundra from Crutchfield for $49.99: https://world wide web.crutchfield.com/p_249RC...7Z2RZGAYBNYowEgQZJzLmXlnoBfy0bgUaAmA9EALw_wcB
Only prob with this photographic camera is the four-pin harness doesn't match the 4-pin receiver at the base of the tailgate on the '08 I accept. Merely the camera, hole saw, and voltage regulator were all perfect. And so I cut off the iv-pin plug and receiver (camera and truck) and soldered in a generic, waterproof four-pin in their identify. Rear-finish solved.

https://hebronautoparts.com/i-25145...0ATr6NXyTKknXbpgyDKRvVGOrAA4QUEkaAnjAEALw_wcB

For the HU, I used this thread : http://world wide web.toyotatundraforum.com/vbcms-comments/1747-pioneer-avic-z2-nav-install-lots.html

... when you get down to the photos where he'south soldering in an RCA connector, that's the department applicative to taping the factory wiring at the lower commuter-side pillar. He'south got an old and new way (new in ruby) that is what you're looking for. So merely wire run was from colonnade nether dash to HU. I've got a really former Pioneer DVD / touchscreen, but fifty-fifty it allowed me to turn on the camera manually whether driving at speed or non, which is exactly what I wanted to monitor the hitch while towing.

Practiced luck.
SRD5000 New Fellow member

Joined:

Sep sixteen, 2019

Fellow member:

#36212

Messages:

1

Gender:

Male person

Offset Proper noun:

Scott

Vehicle:

2010 Double Cab

None

I found this connector higher up my overhead console (2010 Tundra DoubleCab). I'd like to discover a connector for it to connect to an aftermarket rearview camera and mirror-monitor. I've read these threads and searched the heck out of Amazon but can't discover a kit that uses this connector forth with the prewired connector under the truck near the tailgate. Thanks in advance to anyone who can steer me in the right direction.